Call To Order: 1-800-541-9352
1990 Chevrolet S10 Blazer Knock Sensor
Review Fitment NotesFilter By Brand
Related Parts
- A/C Switch Connector
- Alternator
- Alternator Adapter Plug
- Alternator Bearing
- Barometric Pressure Sensor Connector
- Clutch Starter Safety Switch
- Distributor Advance Weight Pin
- Distributor Cap
- Distributor Cap Bolt
- Distributor Cap and Rotor Kit
- Distributor Drive Gear
- Distributor Dust Shield
- Distributor Felt Washer
- Distributor Gasket
- Distributor Housing Gasket
- Distributor Pole Piece Assembly
- Distributor Rotor
- Distributor Shaft Assembly
- Distributor Shaft Thrust Washer
- Distributor Shaft Washer
- EGR Solenoid Valve Connector
- EGR Valve Control Solenoid Connector
- EGR Valve Control Switch
- Electronic Control Unit
- Electronic Spark Control Module
- Electronic Vacuum Regulator Valve Wiring Connector
- Engine Camshaft Position Sensor Connector
- Engine Coolant Temperature Sending Unit Switch Connector
- Engine Coolant Temperature Sensor Connector
- Engine Wiring Harness
- Fuel Pump Cut-Off Switch Connector
- Fuel Pump Harness Connector
- Generator Commutator End Bearing
- Generator Drive End Bearing
- Horn Connector
- Idle Air Control Valve Connector
- Ignition Coil
- Ignition Coil Adapter
- Ignition Coil Connector Kit
- Ignition Control Module Bolt
- Ignition Control Relay
- Ignition Control Unit
- Ignition Crank Trigger Kit
- Ignition Distributor
- Ignition Switch Actuator
- Ignition Switch Connector
- Ignition Tune-Up Kit
- Intake Manifold Temperature Sensor
- Knock Sensor
- Knock Sensor Connector
- Pickup Coil
- Spark Plug
- Spark Plug Heat Shield
- Spark Plug Non-Fouler
- Spark Plug Wire Set
- Starter
- Starter Bearing
- Starter Bushing
- Starter Cable
- Starter Drive
- Starter Heat Shield
- Starter Motor Shim
- Starter Solenoid
- Throttle Position Sensor Connector
- Voltage Regulator
- Voltage Regulator Connector
- Water in Fuel Sensor Connector
Change Category
- Accessories
- Air Intake
- Body Electrical
- Body Mechanical & Trim
- Brake
- Brake Pad Rotor Shoe Drum
- Chemicals and Fluids
- Climate Control
- Clutch
- Cooling System
- Diesel Injection
- Drive Belts
- Driveshaft & Axle
- Engine Mechanical
- Exhaust
- Fluids/Manuals/Misc
- Fuel Delivery
- Fuel Injection
- Steering
- Suspension
- Transmission
Shop By Vehicle
Low Cost From $19.95 to $57.58
Showing 14 of 14 Results


Website Reviews
Loading Reviews...
Replacement Knock Sensor
Part Number: 3651-02554158
Brand: Replacement
Notes: Ignition Knock (Detonation) Sensor -- Ignition Knock Sensor (Detonation Sensor)
Condition: New
Shipping Options: Free Ground Shipping
This Part Fits:
Catalog: E
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 GAS |


Website Reviews
Loading Reviews...
Replacement Knock Sensor
Part Number: 3651-02177627
Brand: Replacement
Notes: Ignition Knock (Detonation) Sensor -- Ignition Knock Sensor (Detonation Sensor)
Condition: New
Shipping Options: Free Ground Shipping
This Part Fits:
Catalog: E
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 GAS |


Website Reviews
Loading Reviews...
DIY Solutions Knock Sensor
Part Number: 3651-07318003
Brand: DIY Solutions
Notes: Ignition Knock (Detonation) Sensor -- V6 4.3L
Condition: New
Shipping Options: Free Ground Shipping
This Part Fits:
Catalog: Q
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 |


5 Stars
Standard Motor Products KS7T
Knock Sensor
Knock Sensor
Loading Reviews...
Standard Motor Products Knock Sensor
Part Number: 3651-05090676
Brand: Standard Motor Products
Notes: Ignition Knock (Detonation) Sensor
Condition: New
Shipping Options: Ground
This Part Fits:
Catalog: B
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 GAS |


Website Reviews
Loading Reviews...
Standard Motor Products Knock Sensor
Part Number: 3651-05060516
Brand: Standard Motor Products
Notes: Ignition Knock (Detonation) Sensor
Condition: New
Shipping Options: Ground
This Part Fits:
Catalog: B
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 GAS |


5 Stars
AC Delco 213-324
Knock Sensor
Knock Sensor
Loading Reviews...
AC Delco Knock Sensor
Part Number: 3651-02386046
Brand: AC Delco
Notes: GM Original Equipment -- New; 1/4-18 NPTF THREAD, MATING CONNECTOR WITH LEADS USE PT308
- GM-recommended replacement part for your GM vehicle's original factory component
- Helps prevent damage to the engine caused by pre-ignition
- Manufactured to GM OE specification for fit, form, and function
- Offering the quality, reliability, and durability of GM OE
- Sends signals to the engine control module (ECM) to adjust timing
Condition: New
Meets or Exceeds OEM Specifications:
Yes
Shipping Options: Ground
This Part Fits:
Catalog: O
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 LB4 VIN: Z |


Website Reviews
Loading Reviews...
Delphi Knock Sensor
Part Number: 3651-05028478
Brand: Delphi
Notes: Ignition Knock (Detonation) Sensor
- 100 years of OE experience, supplier to the world's top automakers, OE Heritage and knowledge built into every aftermarket part.
- Delphi knock sensors help maximize engine performance with all fuels
- Delphi knock sensors prevent against engine damage from pre-ignition knocking
- Flat frequency response allows the same sensor to be used on different engines and the sensor responds to knock frequencies higher than the primary frequency
- Ground-isolated design with 2-wire shielded harness helps protect the sensor signal from electro-magnetic interference (EMI)
- Self-generating piezoelectric design requires no power to the sensor
Condition: New
Shipping Options: Ground
This Part Fits:
Catalog: B
Vehicle |
---|
1990 Chevrolet S10 Blazer |


Website Reviews
Loading Reviews...
Walker Knock Sensor
Part Number: 3651-06181943
Brand: Walker
Notes: FSK
- Walker Products sensors are engineered using high quality components and materials to ensure proper fit and response. All sensors go through an ongoing fit, form, and function process and meet or exceed OE specifications.
- Designed to meet or exceed OE specifications in form, fit and function. Direct fit replacement. Direct fit connectors.
Condition: New
Shipping Options: Ground
This Part Fits:
Catalog: B
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 VIN: Z |


5 Stars
Walker 242-1034
Knock Sensor
Knock Sensor
Loading Reviews...
Walker Knock Sensor
Part Number: 3651-05466077
Brand: Walker
Notes: Ignition Knock (Detonation) Sensor
- Designed to meet or exceed OE specifications in form, fit and function. Direct fit replacement. Direct fit connectors.
- Walker Products sensors are engineered using high quality components and materials to ensure proper fit and response. All sensors go through an ongoing fit, form, and function process and meet or exceed OE specifications.
Condition: New
Shipping Options: Ground
This Part Fits:
Catalog: B
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 VIN: Z |


Website Reviews
Loading Reviews...
NGK Knock Sensor
Part Number: 3651-07420806
Brand: NGK
Notes: NTK Ignition Knock (Detonation) Sensor
- NTK's Ignition Knock Sensors are manufactured to operational performance standards to meet or exceed OE fit, form and function to ensure proper ignition timing. This advanced technology is used for durability, drivability and fuel economy.
- The Ignition Knock (Detonation) Sensor monitors vibrations caused by engine knock, or detonation, to alter the ignition timing and prevent detonation.
- Reinforced and extra-strength components are used to reduce chance of part failure and prevent corrosion and moisture penetration. Mounting threads match OE for easy, worry free installation. Backed by a 3 year/36,000-mile warranty.
Condition: New
Shipping Options: Ground
This Part Fits:
Catalog: C
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 |

Website Reviews
Loading Reviews...
Santech/ Omega Envir. Tech. Knock Sensor
Part Number: W0133-1684604
Brand: Santech/ Omega Envir. Tech.
Condition: New
Shipping Options: Ground, Overnight, 2 Day
This Part Fits:
Catalog: A
Vehicle |
---|
1990 Chevrolet S10 Blazer |


Website Reviews
Loading Reviews...
Forecast Knock Sensor
Part Number: 3651-09189212
Brand: Forecast
Notes: Ignition Knock (Detonation) Sensor
Condition: New
Shipping Options: Ground
This Part Fits:
Catalog: H
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 GAS |


Website Reviews
Loading Reviews...
GPD Knock Sensor
Part Number: 3651-05914090
Brand: GPD
Notes: Ignition Knock (Detonation) Sensor -- Ignition Knock Sensor
- 100% Tested for durability and performance
- Professional quality
- Designed to meet/exceed OE fit, form and function
- The knock sensor is located on the engine block, cylinder head or intake manifold. Its function is to sense unusual vibrations caused by engine pre-ignition or detonation.
- Direct fit replacement
Condition: New
Shipping Options: Ground
This Part Fits:
Catalog: B
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 |


Website Reviews
Loading Reviews...
Holstein Knock Sensor
Part Number: 3651-05899549
Brand: Holstein
Notes: Ignition Knock (Detonation) Sensor
- Holstein utilizes only premium materials to ensure durability and reliable service
- Tested to ensure voltage specifications align with OE standards
- The electronic component continuously monitors sensor output to ensure it responds with the appropriate frequency rate
- Each knock sensor is engineered and designed to meet OE specifications for that vehicle, ensuring ideal performance
- The Piezoelectric disc is a crystalline element that receives the vibrations from the engine, and transmits them to the computer using a voltage signal
- Wire harness comes with protective sleeve to prevent wires from damage
- Global coverage of European, Asian, and Domestic vehicles
Condition: New
Shipping Options: Ground
This Part Fits:
Catalog: B
Vehicle | Engine |
---|---|
1990 Chevrolet S10 Blazer | 4.3L V6 |