BMW 325es Parts

Notes: w/ coil wire

Notes: OEM

Notes: 520mm : 3 wire : 0 258 003 008

Notes: When replacing High Pressure Strut (1 1/2" piston rod), use boot kit SB 101

Notes: One piece from catalyst back.

Notes: w/o ABS : 20.64mm

Notes: Illuminated

Notes: Bolt-on

Notes: Protective boot and bump stop (when applicable) from original shock must be re-installed. Failure to install proper parts will result in damage to shocks and vehicle.

Notes: This sending unit is located in the center (right) of in-tank fuel pump. For sealing o-ring use 16 12 1 150 391. Due to a fuel tank design change, models from production date 10/87 use a second fuel sending unit. This part is 16 14 1 179 720.

Notes: "BMW" - Hood

Notes: New CARB regulations that went into effect on January 1, 2009 now require all exhaust catalyst devices that are sold in California regardless of model year must meet the tougher OBD II emission standards that were introduced in the 1996 model year. Until further notice, this catalytic converter should not be used on vehicles registered in California. To receive a one year warranty, customer must fill out the warranty card and return to Bosal. #BOSALWAR/CAT

Detailed Notes: New CARB regulations that went into effect on January 1, 2009 now require all exhaust catalyst devices that are sold in California regardless of model year must meet the tougher OBD II emission standards that were introduced in the 1996 model year. Until further notice, this catalytic converter should not be used on vehicles registered in California. -- To receive a one year warranty, customer must fill out the warranty card and return to Bosal. #BOSALWAR/CAT

Notes: Note : Does not include exhaust manifold with heat shield. Requires (2) 11 62 1 728 489 per car.

Notes: w/ Keys

Notes: Dual Inlet - Screw-on Fan Clutch

Notes: w/ Bearing